The operators are obligated to be trained on the equipment, usage, inspection and identification on potential risk (CSA B354.2-01 – Article 7.1)
Training Requisite:
The operators are obligated to be trained on the equipment, usage, inspection and identification on potential risk (CSA B354.2-01 – Article 7.1)
Assessment:
To differentiate the principal elements that are required in the operation of the equipment,
Inspection before usage;
To describe the functions and characteristics specific on the equipment;
To detect any defects likely to influence the correct operation of the equipment;
Risk factor associated with aerial work ;
Complete understanding of the name plate;
Usage of harness
Time Frame:
3.5 hours of theory (depending on the type of equipment)
Practice evaluation performed in the work environment (evaluation of approximately half an hour per candidate)
Formation CC's goal is to help you achieve your health and safety objectives. It is imperative to take into account the contextual requirements of each company that requests our services.
In fact, when the situation requires an examination of a problem related to material handling equipment, our trainers can travel to you to develop a proposal on the type of training required.
In addition, we provide training services 24 hours a day, seven days a week, anywhere in Quebec. Each training program is accompanied by the trainer's recommendations, an appreciation and an overall result of the participants, who will receive a training card and certificate after passing the practical evaluation.
Low, Medium & High Angle Rescue course is offered by DSC Safety Services.
This course will provide the learner with the required knowledge to perform a Tower Crane and Construction Rescue from Heights. At the end of this course the learner will be able to demonstrate how to setup and dismantle rescue systems used in typical rescues from a tower crane
Education and training under WHMIS (Workplace Hazardous Materials Information System) can be thought of as two separate parts. Education refers to the instruction of workers in general information such as how WHMIS works and the hazards of controlled products.
The course will educate the students on arc flash and shock hazard identification techniques as well as practical solutions to control the hazards. Offered in partnership with Leaf Electrical Safety, this 8-hour course is intended to give those who work around electricity an understanding of the ha...
This program focuses on safe practices when using scaffolds as work platforms.
© 2024 coursetakers.com All Rights Reserved. Terms and Conditions of use | Privacy Policy