The Magnetic Compass Adjuster course is conducted by experienced faculty who has been doing adjustment out at sea. After going through the course, candidates gain enough confidence to carry out adjustments in ship’s magnetic compass to eliminate / reduce compass error due to ship’s induced magnetism
Following regulations applies to the magnetic compasses carried on board ship:-
(a) SOLAS Consolidated Edition 2004, Ch V, Reg. 19.2
(b) IMO Assembly Resolution A.382(X) – Magnetic Compasses Carriage and Performance Standards
(c) STCW Convention, 1978, as amended, and the STCW Code
(d) ISO Standard 2269:1992 – Class A magnetic compasses, azimuth reading devices and binnacles — Tests and certification
REQUIREMENTS:
(Taken from all above mentioned requirements considering vessels are fitted with class A magnetic compasses)
1.0 Allowed Residual Deviation
1.1 All vessels are required to be fitted with a properly adjusted magnetic compass. The residual deviation, or error, should be 5° or less on all headings.
2.0 When a Compass Should be Adjusted
2.1 Magnetic compasses should be adjusted when:
.1 They are first installed;
.2 They become unreliable;
.3 The observed error consistently exceeds the allowed limit of 5° on one or more headings;
.4 After dry docking, or after repairs or structural alterations have been made to the ship that could affect its permanent and / or induced magnetism (see paragraph 3.1 below);
.5 Electrical or magnetic equipment close to the compass is installed, removed, or altered;
.6 After one (1) year from when the compass was last adjusted if the required record of compass deviations has not been properly maintained or the record of deviations are excessive; and/or
.7 When deemed necessary by the Master.
3.0 Changes in Magnetism During the Life of a Ship
3.1 The magnetism of a new vessel can be particularly unstable. The same is true following major structural repairs or modifications. Therefore, the performance of magnetic compasses should be monitored carefully during the early life of a vessel as well as after repairs or modifications are completed to determine if the compass requires adjustment.
3.2 Masters are advised that it is essential to check the performance of magnetic compasses particularly:
.1 When carrying and after discharging cargoes that have magnetic properties;
.2 After electromagnetic lifting appliances are used for cargo loading or discharging(see paragraph 3.3 below);
.3 Following a casualty in which the vessel has been subject to severe contact or electrical charge, such as a lightning strike; or
.4 After the vessel has been laid up or lying idle since even a short period of idleness can lead to serious deviations, especially for small vessels.
3.3 The retentive magnetic field induced by electromagnetic lifting appliances can alter a vessel’s magnetism, making compasses unreliable. However, a large amount of the magnetism induced by electromagnetic equipment may subsequently decay. Therefore,immediate readjustment is not advised until the residual deviation of the compass has been determined.
4.0 Monitoring Compass Deviation
4.1 A magnetic compass’ error should be determined at least once a watch while the vessel is at sea and, when possible, after any major alteration of course. The observed error should be recorded in a compass deviation book. Checking the compass deviation regularly may show the need for repair, testing or adjustment. In addition, compasses should be inspected occasionally by a competent officer or compass adjuster. An entry should be made in the compass deviation book when a vessel enters and leaves dry dock.
5.0 Compass Adjustments and Repairs
5.1 Adjustment must be made by a duly authorized compass adjuster. If a qualified and certified compass adjuster is unavailable and the Master considers it necessary, then adjustments may be made by the Master provided he has the necessary expertise. Under no circumstances should the same person who surveyed a vessel carry out the compass adjustment or repairs.
5.2 The date of any adjustment and other details should be noted in the compass deviation book. Such details should include the position of all compass correctors as well as the vessel’s position and sea conditions when the adjustments were made.
5.3 A compass deviation card should be prepared each time the compass is adjusted. Separate deviation cards should be prepared for the standard compass and the transmitting magnetic compass repeater, if fitted, by comparing headings.
5.4 Repairs should only be made by the compass manufacturer or other competent person or company using proper test facilities. When the work is finished the repairer should supply the Owner or Master with a certificate specifying the date the work was done and the applicable standards.
Responsibility for Maintenance
The Owner and the Master are responsible for ensuring that compasses on their ships are maintained in good working order.
Target Audience
This course is for ship’s Master and navigational officers. However Electronic Navigational Aid service technicians are also welcome to learn the tricks of Magnetic Compass Adjustment.
Course Content magnetic compass adjuster
Day : 1 (Theory)
Introduction including legal aspects and requirements
Principle of compass adjustment
Obtaining Magnetic Variation of a place
Magnetic effects of electrical currents
Ships magnetism
Effects of permanent and induced magnetism
Compass design – general principles
Compass compensations
Use of Gauss meter in adjusting Heeling magnets
Magnetic effects of Northern and Southern Hemisphere on Heeling correctors
Coefficient A,B.C,D and E
The various types of transmitting magnetic compass bowls and repeaters
Compass Repairs and Compass liquid characteristics
Removing the bubble in compass
Methods of detecting mechanical errors in compasses at sea
Assessment of safe distances of navigational and other equipment of the Compass
Elite Offshore Academy has been established to provide quality training to the people working in the Offshore, Marine and General Industry (OSHA).
Most of our courses are unique and futuristic in nature that have been designed by experience and are adhering to latest guidelines promulgated by global competent authorities. Although we started with focus on offshore sector, with demand, we have been slowly shifting towards OSHA.
The courses are conducted by trained and qualified faculties who have several years of working experience in the industry. The centre uses latest aids and equipment to impart training.
Elite Offshore is very conveniently located at the kharghar, sector 2, Little World Mall, 1st floor, Unit 123 The centre aims at providing cost effective solution to the ever-increasing training requirement of Offshore, Marine and OSHA Industry.
Training programs may be customized or scheduled to suit specific needs of companies or groups of students.
Elite Offshore offers Ship-to-Ship (STS) training tailored for individuals operating at sea or exposed to maritime environments like dock workers. STS transfer operations are standard in the shipping industry, facilitating the direct transfer of various cargoes between two seagoing vessels.
The course aims to train delegates to perform these duties efficiently and safely, both under normal conditions and emergency situations. The course covers various aspects related to helicopter operations at an offshore mining installation, including hazards associated with helicopter operations, i...
The aim and objectives of the HLO / HERTL Training Programme are to equip the delegate with the initial knowledge, understanding and skills required to perform the role of Offshore Helicopter Landing Officer (HLO) safely and effectively. HLO’s to understand the importance of pre-planning for and...
Embark on a career as a Pump Man with Elite Offshore's Marine Pumpman course. Learn essential duties and responsibilities for ship operations. Enroll today!
The Ship Recycling - Hongkong Convention training, conducted by Elite Offshore, is for anyone working at sea, or dock workers exposed to sea. This training is designed to educate and train individuals working at sea or dock workers who may be exposed to ships undergoing recycling processes.
© 2024 coursetakers.com All Rights Reserved. Terms and Conditions of use | Privacy Policy