COURSES OFFERED BY WELL CONTROL GROUP

This course is a basic introduction to Arc Flash and the hazards that are involved.

This course is designed to provide students with a basic knowledge of H2S properties and health Hazards.

The primary objective of this aerial lifts operator training program is to provide you with the knowledge and skill required to demonstrate safe, competent operation of the equipment addressed.

Regardless of your previous experience, this program is applicable to all forklift operators

The Lockout/Tagout course is designed to ensure employers, management, and workers understand the hazards that are associated with the controlled energy and the proper methods of controlling energy through a properly developed and implemented lockout program.

This course is designed to familiarize workers with basic Overhead Crane Rigging concepts and proper inspection criteria, the proper uses of slings and associated rigging equipment as well as the proper pre-use inspection procedures for rigging equipment.

This course is designed to familiarize workers with basic Rigging and Slinging concepts, the proper uses of slings and associated rigging equipment as well as the proper pre-use inspection procedures for rigging equipment.

Safe Rigging Practices as well as load weight estimation and the importance of proper sling angles are also covered in order to give participants the skills needed to safely preform the job of Rigger/Signaler/Banksman

This course was designed to give basic instruction on the safe erection and dismantling of Tube and Clamp Scaffolding in a residential/commercial environment.

All traffic control persons in Newfoundland and Labrador are required to complete a TCP training course. Proper traffic control is critical for the safety of workers, drivers and the general public.